Document LTP0101 rev 2.1f
Water Flow Rates
Maintain water flow rates as indicated. Please note, these specifications relate to the heat pump only. Code-specified whole system turnover rates must be satisfied.
NOTICE
Failure to heed the following may result in damage to equipment.
- Water flow exceeding maximum flow rates will negatively affect the total pool filtration performance and may damage the heat pump. This will not be covered under equipment warranty.
| MODEL | SOURCE | HEAT EXCHANGER TYPE | FLOW RATES | |
|---|---|---|---|---|
| MINIMUM | MAXIMUM | |||
| SP05 | Source-Side | Titanium ThermoLink® | 20 GPM | 70 GPM |
| Spa Side | Titanium ThermoLink® | 30 GPM | 70 GPM | |
Please note -
If minimum flow rates are not met, heat pump performance is reduced and performance will suffer. Internal safety devices may deactivate the heat pump with the following errors:
- HP and HP5
- or (if equipped) error codes of LP and LP5
- Operate water filtration devices per manufacturer's specifications. Dirty filters can cause a reduction of water flow to the heat pump. An increase of 7-10 psi higher than the clean filter pressure typically reduces flow rates. This requires the filter to be cleaned or back-washed.
- Keep baskets free of debris. A large quantity of debris in the pump and skimmer baskets can reduce water flow.
- Check for improper valve settings. A partially closed valve after the filter, or a full-open bypass around the heat pump, will cause insufficient water flow through the heat pump.
- The maximum static pressure (or operating pressure) is 50 pounds-per-square-inch (PSI)
- Code-specified whole system turnover rates must be satisfied.